Education
Open the driver’s door of the Agreement. Remove the door panel door switch with a flathead screwdriver to lift the front door switch panel. Remove the switch panel interior door panel by hand, but do not remove the electrical connectors on the rear panel switches.
Remove the four mounting screws on the bottom of the door panel; center screw extractor mounted on the door handle and door handles screw with a Phillips screwdriver. Remove all plastic snaps that hold the door panel by leveraging the entire inner door panel with a flathead screwdriver.
Pull the door panel and to the machine frame to remove the door. Push the panel window switch panel through the revolving door, sending him through the door panel lengthwise. Leave the switch panel hangs while the panel door Accord is removed.
Turn the ignition switch to “II” or “Accessories” position. This is where all the dashboard lights come on, but the motor does not rotate. Do not start the vehicle for this procedure. Coil driver’s window halfway up the control panel window so as to be seen in the bottom of the window. If the window motor not working at all, skips this step and go to step 5.
Place a ratchet quarter-inch and socket in the door frame and the support pins in the bottom of the base of the window glass. There are two screws on the two different supports that attach the window glass for window regulator. The glass must be removed before removing the motor controller. Turn the screws fixing the glass in the left window to remove the controlling group.
Lift the glass door and door frame. Place the glass door on the passenger seat of the Agreement for safekeeping.
Remove the mounting bolts of the window regulator motor, with a ratchet 1/4-inch ratchet and socket with an extension of 6 inches. The extension will allow a greater flow without putting your hands near the metal edge of the doorframe. Leave the window regulator fall to the bottom of the door frame after removing the screws.
Remove the mounting bolts window motor from the frame of the door turning left with a ratchet 1/4-inch ratchet and socket. Remove the window regulator motor with one hand. Disconnect the electrical connection from the back of the engine with the other hand, simply by pressing the connector and pulling it free from the motor. Remove the engine Accord.